If not ,How can we monitor traffic using wireshark in above case? If yes, How does Sw1 determine the destination port F1/2 is located on different switch sw3? We wish to capture traffic sw1's f1/1 using wireshark connected to sw3's f1/2. What about if the source port is located on different switch as shown below: Monitor session 1 destination interface FastEthernet1/2 Monitor session 1 source interface FastEthernet1/1 both Here source port and destination port both are on the same switch.I used these commands on sw1 and I was able to capture traffic : I encountered a situation where i had to monitor traffic on a switch port using wireshark as shown below:
0 Comments
Leave a Reply. |